Reference Guide

Control and Monitoring | 99
Related
Commands
power-on
c e
Turn on power to a line card or the standby (extra) Switch Fabric Module (SFM).
Syntax
power-on {linecard number | sfm sfm-slot-id}
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
Related
Commands
reload
c e s
Reboot FTOS.
Syntax
reload
Command Modes
EXEC Privilege
Command
History
Usage
Information
If there is a change in the configuration, FTOS will prompt you to save the new configuration. Or you
can save your running configuration with the copy running-config command.
Related
Commands
power-on Power on a line card or standby SFM.
linecard number Enter the keyword linecard and a number for the line card slot number.
C-Series Range: 0-7
E-Series Range: 0 to 13 on a E1200/E1200i, 0 to 6 on a E600/E600i, and 0 to 5 on a
E300.
sfm standby Enter the keyword sfm followed by the slot number of the SFM to power on.
Note: This option is supported on E-Series only.
Version 8.1.1.2 Introduced on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale E1200i
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
power-off Power off a line card or standby SFM.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
reset Reset a line card, RPM, a standby SFM (EtherScale only), or a failed SFM
(TeraScale and ExaScale).
reset stack-unit Reset any designated stack member except the management unit