Reference Guide

Neighbor Discovery Protocol (NDP) | 983
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Example
Figure 36-1. show ipv6 neighbors Command Example
cpu Enter the keyword cpu followed by either rp1 or rp2 (Route Processor 1
or 2), optionally followed by an IPv6 address to display the IPv6 neighbor
entries stored on the designated RP.
interface interface
• For a Fast Ethernet interface, enter the keyword fastEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number from 1 to 255.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by the VLAN ID. The
range is from 1 to 4094.
FTOS#show ipv6 neighbors
IPv6 Address Expires(min) Hardware Address State Interface VLAN CPU
------------------------------------------------------------------------------
fe80::201:e8ff:fe17:5bc6
1439 00:01:e8:17:5b:c6 STALE Gi 1/9 - CP
fe80::201:e8ff:fe17:5bc7
1439 00:01:e8:17:5b:c7 STALE Gi 1/10 - CP
fe80::201:e8ff:fe17:5bc8
1439 00:01:e8:17:5b:c8 STALE Gi 1/11 - CP
fe80::201:e8ff:fe17:5caf
0.3 00:01:e8:17:5c:af REACH Po 1 - CP
fe80::201:e8ff:fe17:5cb0
1439 00:01:e8:17:5c:b0 STALE Po 32 - CP
fe80::201:e8ff:fe17:5cb1
1439 00:01:e8:17:5c:b1 STALE Po 255 - CP
fe80::201:e8ff:fe17:5cae
1439 00:01:e8:17:5c:ae STALE Gi 1/3 Vl 100 CP
fe80::201:e8ff:fe17:5cae
1439 00:01:e8:17:5c:ae STALE Gi 1/5 Vl 1000 CP
fe80::201:e8ff:fe17:5cae
1439 00:01:e8:17:5c:ae STALE Gi 1/7 Vl 2000 CP
FTOS#