Reference Guide

Control and Monitoring | 97
Defaults
See parameters above.
Command Modes
EXEC
EXEC Privilege
Command
History
pattern pattern
(IPv4 only) Enter the IPv4 data pattern.
Range: 0-FFFF
Default:
0xABCD
sweep-min-size
Enter the minimum size of datagram in sweep range.
Range: 52-15359 bytes
sweep-max-size
Enter the maximum size of datagram in sweep range.
Range: 53-15359 bytes
sweep-interval
Enter the incremental value for sweep size.
1-15308 seconds
ointerface
(IPv4 only) Enter the outgoing interface for multicast packets.
• Enter the IP address in A.B.C.D format
• For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale
• E-Series only For the SONET interfaces, enter the keyword
sonet followed
by slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.4.1.0 IPv6 pinging available on management interface.
Version 8.3.1.0 Introduced extended ping options.
Version 8.2.1.0 Introduced on E-Series ExaScale (IPv6)
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4)
Version 7.9.1.0 Introduced VRF
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced support for C-Series
Version 7.4.1.0 Added support for IPv6 address on E-Series