Reference Guide

964 | Multicast
www.dell.com | support.dell.com
show ip mroute
c e s
View the Multicast Routing Table.
Syntax
show ip mroute [static | group-address [source-address] | active [rate] | count | snooping
[vlan vlan-id] [group-address [source-address]] | summary]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
Figure 35-2. show ip mroute static Command Example
static
(OPTIONAL) Enter the keyword static to view static multicast routes.
group-address
[source-address]
(OPTIONAL) Enter the multicast group-address to view only routes associated
with that group.
Enter the source-address to view routes with that group-address and
source-address.
active [rate]
(OPTIONAL) Enter the keyword active to view only active multicast routes.
Enter a rate to view active routes over the specified rate.
Range: 0 to 10000000
count
(OPTIONAL) Enter the keyword count to view the number of multicast routes
and packets on the E-Series.
snooping
[
vlan vlan-id]
[
group-address
[
source-address]]
(OPTIONAL) E-Series ExaScale only:
Enter the keyword snooping to display information on the multicast routes
discovered by PIM-SM snooping.
Enter a VLAN ID to limit the information displayed to the multicast routes
discovered by PIM-SM snooping on a specified VLAN. Valid VLAN IDs: 1 to
4094.
Enter a multicast group address and, optionally, a source multicast address in
dotted decimal format (A.B.C.D) to limit the information displayed to the
multicast routes discovered by PIM-SM snooping for a specified multicast group
and source.
summary (OPTIONAL) Enter the keyword summary to view routes in a tabular format.
Version 8.4.1.1 Support for the snooping keyword and optional vlan vlan-id, group-address, and
source-address parameters were added on E-Series ExaScale.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
FTOS#show ip mroute static
Mroute: 23.23.23.0/24, interface: Lo 2
Protocol: static, distance: 0, route-map: none, last change: 00:00:23