Reference Guide

Multicast Listener Discovery (MLD) | 917
Command
History
ipv6 mld explicit-tracking
e
Enable MLD explicit tracking of receivers.
Syntax
ipv6 mld explicit-tracking
To disable explicit tracking, use the no ipv6 mld explicit-tracking command.
Defaults
Disabled
Command Modes
INTERFACE (conf-if)
Command
History
Usage
Information
If snooping is enabled on the VLAN, this command has no effect. Enable ipv6 mld snooping
explicit tracking instead.
ipv6 mld last-member-query-interval
e
Change the MAX Response Time inserted into the Group-Specific Queries sent in response to a Leave
Group messages. This interval is also the interval between Group-Specific Query messages.
Syntax
ipv6 mld last-member-query-interval {milliseconds}
To return to the default, use the no ipv6 mld last-member-query-interval {milliseconds}
command.
Parameters
Defaults
1000 milliseconds
Command Modes
INTERFACE (conf-if)
Command
History
ipv6 mld querier-timeout
e
Change the interval that must pass before a multicast router decides that there is no longer another
multicast router that should be the querier.
Syntax
ipv6 mld querier-timeout {seconds}
To return to the default, use the no ipv6 mld querier-timeout command.
Version 7.4.1.0 Introduced
Version 7.4.1.0 Introduced
milliseconds
Enter the last member query interval in milliseconds.
Range: 200 - 60000
Default: 1000
Version 7.4.1.0 Introduced