Reference Guide

Link Layer Detection Protocol (LLDP) | 901
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
disable
c e s
Enable or disable LLDP.
Syntax
disable
To enable LLDP, use the no disable
Defaults
Enabled, that is no disable
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Related
Commands
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitEthernet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
Note: The FastEthernet option is not supported on S-Series.
all (OPTIONAL) Enter the keyword all to display information on all interfaces.
events (OPTIONAL) Enter the keyword events to display major events such as timer
events.
packet (OPTIONAL) Enter the keyword packet to display information regarding packets
coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet information.
detail (OPTIONAL) Enter the keyword detail to display detailed packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit only packet information.
rx (OPTIONAL) Enter the keyword rx to display receive only packet information
both (OPTIONAL) Enter the keyword both to display both receive and transmit packet
information.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
protocol lldp (Configuration) Enable LLDP globally.
debug lldp interface Debug LLDP