Reference Guide

90 | Control and Monitoring
www.dell.com | support.dell.com
Usage
Information
You must also configure a password with the ip ftp password command.
Related
Commands
ip telnet server enable
c e s
Enable the Telnet server on the switch.
Syntax
ip telnet server enable
To disable the Telnet server, execute the no ip telnet server enable command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command
History
Related
Commands
ip telnet source-interface
c e s
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
Parameters
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
ip ftp password Set the password for FTP connections.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series
ip ssh server
Enable SSH server on the system
.
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero
(0) to 16383.
• For the SONET interfaces, enter the keyword
sonet followed by slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.