Reference Guide

898 | Link Layer Detection Protocol (LLDP)
www.dell.com | support.dell.com
The information distributed by LLDP is stored by its recipients in a standard Management Information
Base (MIB). The information can be accessed by a network management system through a
management protocol such as SNMP.
See the Link Layer Discovery Protocol chapter of the FTOS Configuration Guide for details on
implementing LLDP/LLDP-MED.
advertise dot1-tlv
c e s
Advertise dot1 TLVs (Type, Length, Value).
Syntax
advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id | vlan-name}
To remove advertised dot1-tlv, use the no advertise dot1-tlv {port-protocol-vlan-id |
port-vlan-id | vlan-name} command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Related
Commands
advertise dot3-tlv
c e s
Advertise dot3 TLVs (Type, Length, Value).
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-size} command.
Parameters
port-protocol-vlan-id Enter the keyword port-protocol-vlan-id to advertise the port protocol
VLAN identification TLV.
port-vlan-id Enter the keyword port-vlan-id to advertise the port VLAN identification
TLV.
vlan-name Enter the keyword vlan-name to advertise the vlan-name TLV. This
keyword is only supported on C-Series and S-Series.
Version 7.7.1.0
Introduced on S-Series, added
vlan-name option.
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
protocol lldp (Configuration) Enable LLDP globally.
debug lldp interface Debug LLDP
show lldp neighbors Display the LLDP neighbors
show running-config lldp Display the LLDP running configuration
max-frame-size Enter the keyword max-frame-size to advertise the dot3 maximum frame size.