Reference Guide

Control and Monitoring | 89
ip ftp source-interface
c e s
Specify an interface’s IP address as the source IP address for FTP connections.
Syntax
ip ftp source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
Related
Commands
ip ftp username
c e s
Assign a user name for outgoing FTP connection requests.
Syntax
ip ftp username username
Parameters
Defaults
No user name is configured.
Command Modes
CONFIGURATION
Command
History
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from
zero (0) to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale
• For SONET interface types, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
copy Copy files from and to the switch.
username
Enter a text string as the user name up to 40 characters long.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series