Reference Guide

880 | Layer 2
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
show mac-address-table
c e s
Display the MAC address table..
Syntax
show mac-address-table [dynamic | static] [address mac-address | interface interface |
vlan vlan-id] [count [vlan vlan-id] [interface interface-type [slot [/port]]]]
Parameters
interface interface (OPTIONAL) Enter the keyword interface followed by the interface type,
slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
S-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display
the MAC address assigned to the VLAN.
Range: 1 to 4094.
Version 7.6.1.0 This version of the command introduced for S-Series
Note: Sticky MAC is not supported on the S25 or S50 in FTOS release 8.4.2.6.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch. Optionally, you can also add
one of these combinations:
address/mac-address, interface/
interface, or vlan vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC address
specifically configured on the switch. Optionally, you can also add one of
these combinations:
address/mac-address, interface/interface, or
vlan vlan-id.
address mac-address (OPTIONAL) Enter the keyword address followed by a MAC address in
the nn:nn:nn:nn:nn:nn format to display information on that MAC address.