Reference Guide

870 | Layer 2
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Related
Commands
mac-address-table station-move threshold
c e
Change the frequency with which the MAC address station-move trap is sent after a MAC address
changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a
given interval.
Syntax
[no] mac-address-table station-move threshold number interval count
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
mac-address
Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output followed by one of the following interfaces:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
vlan vlan-id Enter the keyword vlan followed by a VLAN ID.
Range:1 to 4094.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
show mac-address-table Displays the MAC address table.
threshold number
Enter the keyword threshold followed by the number of times MAC
addresses in VLANs can change before an SNMP trap is sent.
Range: 1 to 10
interval seconds
Enter the keyword interval followed by the number of seconds.
Range: 5 to 60
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series