Reference Guide

Layer 2 | 867

Layer 2

Overview

This chapter describes commands to configure Layer 2 features. It contains the following sections:

• MAC Addressing Commands

• Virtual LAN (VLAN) Commands

Some MAC addressing commands are supported only on the E-Series, some on all three Dell Force10

platforms and some on two Dell Force10 platforms. Support is indicated by these characters, where

appropriate, under each command heading:

c e s

The VLAN commands are supported on all three Dell Force10 platforms — c e s

MAC Addressing Commands

The following commands are related to configuring, managing, and viewing MAC addresses:

• clear mac-address-table dynamic

• mac accounting destination

• mac-address-table aging-time

• mac-address-table static

• mac-address-table station-move threshold

• mac-address-table station-move time-interval

• mac-address-table station-move refresh-arp

• mac cam fib-partition

• mac learning-limit

• mac learning-limit learn-limit-violation

• mac learning-limit station-move-violation

• mac learning-limit reset

• show cam mac linecard (count)

• show cam maccheck linecard

• show cam mac linecard (dynamic or static)

• show cam mac stack-unit

• show mac-address-table

• show mac-address-table aging-time

• show mac accounting destination

• show mac cam