Reference Guide

864 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
lacp system-priority
c e s
Configure the LACP system priority.
Syntax
lacp system-priority priority-value
Parameters
Defaults
32768
Command Modes
CONFIGURATION
Command
History
port-channel mode
c e s
Configure the LACP port channel mode.
Syntax
port-channel number mode [active] [passive] [off]
Parameters
* The LACP modes are defined in the table below.
Defaults
off
Command Modes
INTERFACE
Command
History
Usage
Information
The LACP modes are defined in the following table.
priority-value
Enter the system-priority value. The higher the value, the lower the priority.
Range: 1 to 65535
Default: 32768
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series
number Enter the keyword port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
active Enter the keyword active to set the mode to the active state.*
passive Enter the keyword passive to set the mode to the passive state.*
off Enter the keyword off to set the mode to the off state.*
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced