Reference Guide

862 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
Defaults
Without a Port Channel specified, the command clears all Port Channel counters.
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
debug lacp
c e s
Debug LACP (configuration, events etc.)
Syntax
debug lacp [config | events | pdu [in | out | [interface [in | out]]]]
To disable LACP debugging, use the no debug lacp [config | events | pdu [in | out | [interface
[in | out]]]] command.
Parameters
Defaults
This command has no default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series
show lacp Display the lacp configuration
config (OPTIONAL) Enter the keyword config to debug the LACP configuration.
events (OPTIONAL) Enter the keyword events to debug LACP event information.
pdu in | out (OPTIONAL) Enter the keyword pdu to debug LACP Protocol Data Unit
information. Optionally, enter an
in or out parameter to:
• Receive enter
in
• Transmit enter out
interface in | out
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Optionally, enter an
in or out parameter:
• Receive enter
in
• Transmit enter out
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series