Reference Guide

Control and Monitoring | 81
Command
History
Usage
Information
The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
Figure 5-3. Command Example: do
enable
c e s
Enter the EXEC Privilege mode or any other privilege level configured. After entering this command,
you may need to enter a password.
Syntax
enable [level]
Parameters
Defaults
15
Command Modes
EXEC
Command
History
Usage
Information
Users entering the EXEC Privilege mode or any other configured privilege level can access
configuration commands. To protect against unauthorized access, use the enable password command to
configure a password for the enable command at a specific privilege level. If no privilege level is
specified, the default is privilege level 15.
Related
Commands
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series
FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
level
(OPTIONAL) Enter a number for a privilege level of FTOS.
Range: 0 to 15.
Default: 15
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
enable password Configure a password for the enable command and to access a privilege level.