Reference Guide

808 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
redistribute
c e
Redistribute routes into BGP.
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static] [route-map map-name]
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
If you do not configure default-metric command, in addition to the redistribute command, or there is no
route map to set the metric, the metric for redistributed static and connected is “0”.
To redistribute the default route (0::0/0) configure the neighbor default-originate command.
Related
Commands
show ip bgp ipv6 unicast
c e
View the current MBGP routing table for the E-Series.
Syntax
show ip bgp ipv6 unicast [network [network-mask] [length]]
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor default-originate Inject the default route.
network
(OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask
(OPTIONAL) Enter the network mask (in slash prefix format) of the BGP network
address.
longer-prefixes (OPTIONAL) Enter the keyword longer-prefixes to view all routes with a
common prefix.