Reference Guide

Control and Monitoring | 79
configure
c e s
Enter the CONFIGURATION mode from the EXEC Privilege mode.
Syntax
configure [terminal]
Parameters
Command Modes
EXEC Privilege
Command
History
Example
Figure 5-2. Command Example: configure
debug cpu-traffic-stats
c e s
Enable the collection of CPU traffic statistics.
Syntax
debug cpu-traffic-stats
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
Usage
Information
This command enables (and disables) the collection of CPU traffic statistics from the time this
command is executed (not from system boot). However, excessive traffic received by a CPU will
automatically trigger (turn on) the collection of CPU traffic statics. The following message is an
indication that collection of CPU traffic is automatically turned on. Use the show cpu-traffic-stats to
view the traffic statistics.
Excessive traffic is received by CPU and traffic will be rate controlled.
Related
Commands
terminal (OPTIONAL) Enter the keyword terminal to specify that you are configuring from the
terminal.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
FTOS#configure
FTOS(conf)#
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
Note: This command must be enabled before the show cpu-traffic-stats command will display
traffic statistics. Dell Force10 recommends that you disable debugging (no debug
cpu-traffic-stats) once troubleshooting is complete.
show cpu-traffic-stats Display cpu traffic statistics