Reference Guide

774 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
neighbor subnet
c e
Enable passive peering so that the members of the peer group are dynamic
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet subnet-number mask
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
neighbor timers
c e
Set keepalive and hold time timers for a BGP neighbor or a peer group.
Syntax
neighbor {ipv6-address | peer-group-name} timers keepalive holdtime
To return to the default values, use the no neighbor {ipv6-address | peer-group-name} timers
command.
Parameters
Defaults
keepalive = 60 seconds; holdtime = 180 seconds.
Command Modes
ROUTER BGP
subnet-number
Enter a subnet number in dotted decimal format (A.B.C.D.) as the allowable range of
addresses included in the Peer group.
To allow all addresses, enter 0::0/0.
mask
Enter a prefix mask in / prefix-length format (/x).
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to set the timers for all routers within
the peer group.
keepalive
Enter a number for the time interval, in seconds, between keepalive
messages sent to the neighbor routers.
Range: 1 to 65535
Default: 60 seconds
holdtime
Enter a number for the time interval, in seconds, between the last
keepalive message and declaring the router dead.
Range: 3 to 65535
Default: 180 seconds