Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 769
neighbor peer-group passive
c e
Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message,
but will respond to one.
Syntax
neighbor peer-group-name peer-group passive
To delete a passive peer-group, use the no neighbor peer-group-name peer-group passive
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
Usage
Information
After you configure a peer group as passive, you must assign it a subnet using the neighbor subnet
command.
Related
Commands
neighbor remote-as
c e
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ipv6-address | peer-group-name} remote-as
number command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
neighbor remote-as Assign a indirectly connected AS to a neighbor or peer group.
neighbor shutdown Disable a peer or peer group.
peer-group-name
Enter a text string up to 16 characters long as the name of the peer group.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor subnet Assign a subnet to a dynamically-configured BGP neighbor.
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to enter the remote AS into routing
tables of all routers within the peer group.
number
Enter a number of the AS.
Range: 1 to 65535.