Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 759
Command
History
Related
Commands
distance bgp
c e
Configure three administrative distances for routes.
Syntax
distance bgp external-distance internal-distance local-distance
To return to default values, enter no distance bgp.
Parameters
Defaults
external-distance = 20; internal-distance = 200; local-distance = 200.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The higher the administrative distance assigned to a route means that your confidence in that route is
low. Routes assigned an administrative distance of 255 are not installed in the routing table.
Routes from confederations are treated as internal BGP routes.
maximum-paths
c e
Configure the maximum number of parallel routes (multipath support) BGP supports.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
router bgp Enter ROUTER mode on the switch.
external-distance
Enter a number to assign to routes learned from a neighbor external to the AS.
Range: 1 to 255.
Default: 20
internal-distance
Enter a number to assign to routes learned from a router within the AS.
Range: 1 to 255.
Default: 200
local-distance
Enter a number to assign to routes learned from networks listed in the network
command.
Range: 1 to 255.
Default: 200
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
Caution: Dell Force10 recommends that you do not change the administrative distance of
internal routes. Changing the administrative distances may cause routing table inconsistencies.