Reference Guide

748 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Related
Commands
Command
History
capture bgp-pdu neighbor (ipv6)
c e
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv6-address command.
Parameters
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
capture bgp-pdu max-buffer-size
c e
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
Defaults
40960000 bytes
clear ip bgp ipv6 unicast soft
in
Activate inbound policies for IPv6 routes without resetting the BGP TCP
session.
Version 8.4.1.0 Added support for IPv4 multicast and IPv6 unicast address families
Version 7.8.1.0 Introduced support on S4810
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced on E-Series TeraScale
ipv6-address
Enter the IPv6 address of the target BGP neighbor.
direction {both |
rx | tx}
Enter the keyword direction and a direction— either rx for inbound, tx for
outbound, or
both.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
capture bgp-pdu max-buffer-size Enable route reflection between route reflector and clients.
show capture bgp-pdu neighbor Configure a route reflector and clients.
capture bgp-pdu neighbor Enable capture of an IPv4 BGP neighbor packet.
100-102400000
Enter a size for the capture buffer.