Reference Guide

740 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Related
Commands
bgp confederation identifier
c e
Configure an identifier for a BGP confederation.
Syntax
bgp confederation identifier as-number
To delete a BGP confederation identifier, use the no bgp confederation identifier as-number
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
Usage
Information
The autonomous systems configured in this command are visible to the EBGP neighbors. Each
autonomous system is fully meshed and contains a few connections to other autonomous systems. The
next hop, MED, and local preference information is preserved throughout the confederation.
FTOS accepts confederation EBGP peers without a LOCAL_PREF attribute. The software sends
AS_CONFED_SET and accepts AS_CONFED_SET and AS_CONF_SEQ.
bgp confederation peers
c e
Specify the Autonomous Systems (ASs) that belong to the BGP confederation.
Syntax
bgp confederation peers as-number [...as-number]
To enter no bgp confederation peer.
Parameters
Defaults
Not configured.
bgp client-to-client reflection Enable route reflection between route reflector and clients.
neighbor route-reflector-client Configure a route reflector and clients.
show ip bgp ipv6 unicast
cluster-list
View paths with a cluster ID.
as-number
Enter the AS number.
Range: 1 to 65535
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
as-number
Enter the AS number.
Range: 1 to 65535
...as-number
(OPTIONAL) Enter up to 16 confederation numbers.
Range: 1 to 65535.