Reference Guide

IPv6 Basics | 723
show ipv6 cam linecard
c e s
Displays the IPv6 CAM entries for the specified line card.
Syntax
show ipv6 cam linecard slot-number port-set {0-1} [summary | index | ipv6 address]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
The forwarding table displays host route first, then displays route originated by routing protocol
including static route.
The egress port section displays the egress port of the forwarding entry which is designated as:
C for the Control Processor
1 for the Route Processor 1
2 for the Route Processor 2
slot-number
Enter the line card slot ID number.
Range: 0 to 13 on the E1200; 0 on 6 for E600, and 0 to 5 on the E300.
port-set
Enter the Port Set to
summary
(OPTIONAL) Enter the keyword
summary to display a table listing network
prefixes and the total number prefixes which can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM
ipv6-address
Enter the IPv6 address in the
x:x:x:x::x/n format to display networks that have
more specific prefixes.
Range: /0 to /128
Note: The
:: notation specifies successive hexadecimal fields of zeros.
Version 8.4.2.1 Introduced on S-Series
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series TeraScale
Note: If a link-local IPv6 address is statically configured and dynamically learned on a C-Series router, the
dynamically -learned IPv6 address is displayed in show ipv6 cam linecard output, but the statically-configured
IPv6 address may not be displayed. Use the show ipv6 fib linecard or show ipv6 neighbors commands to
display statically-configured addresses of IPv6 neighbors.