Reference Guide

704 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ACCESS-LIST
Command
History
Related
Commands
destination address
Enter the IPv6 address of the network or host to which the packets are sent in
the
x:x:x:x::x format followed by the prefix length in the /x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zero.
message-type
(OPTIONAL) Enter an ICMP message type, either with the type (and code, if
necessary) numbers or with the name of the message type.
Range: 0 to 255 for ICMP type; 0 to 255 for ICMP code
count (OPTIONAL) Enter the keyword count to count packets processed by the
filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
log (OPTIONAL) Enter the keyword log to enter ACL matches in the log.
Supported on Jumbo-enabled line cards only.
monitor (OPTIONAL) Enter the keyword monitor to monitor traffic on the
monitoring interface specified in the flow-based monitoring session along
with the filter operation.
Version 8.4.2.1 Introduced on the E-Series TeraScale and S-Series
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Introduced on the C-Series
Version 7.4.1.0
Added
monitor option
deny Configure a filter to drop packets.
permit Configure a filter to forward packets.