Reference Guide

668 | IPv4 Routing
www.dell.com | support.dell.com
S-Series produces the following error message:
%Error: Unable to read IP route table
C-Series produces the message:
%Error: FIB cannot compute the egress port with the current trunk hash
setting.
Example
Figure 24-15. Command Example show ip flow on E-Series
show ip interface
c e s
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief | linecard slot-number] [configuration]
Parameter
FTOS#show ip flow interface Gi 1/8 189.1.1.1 63.0.0.1 protocol tcp source-port 7898 destination-port 897
6
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface: Gi 1/20
Egress interface: Gi 1/14 to 1.7.1.2[CAM hit 103710] unfragmented packet
Gi 1/10 to 1.2.1.2[CAM hit 103710] fragmented packet
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
Loopback followed by a number
from 0 to 16383.
• For the Management interface, enter the keyword
ManagementEthernet
followed by zero (0).
• For the Null interface, enter the keyword
null followed by zero (0).
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and
whether an IP address is assigned.