Reference Guide

66 | BOOT_USER Mode
www.dell.com | support.dell.com
ignore startup-config
s
During a reload, do not load the startup-config file.
Syntax
ignore startup-config
Defaults
disabled
Command Modes
BOOT_USER
Command
History
Usage
Information
This command might be used if a the user has authentication procedures in the startup-config other
than the enable-password setting.
interface management ethernet ip address
c e s
Assign an IP address to the Management Ethernet interface.
Syntax
[no] interface management ethernet ip address ip-address mask
To delete the IP address on the C-Series and E-Series (not on S-Series), enter no interface
management ethernet ip address.
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
In the runtime CLI of the C-Series and E-Series (not on S-Series), use the ip address command in the
INTERFACE mode to change the Management interface’s IP address.
If there is a mac address programmed in the eeprom, the show interface management ethernet
command gets the mac address from there and displays it. If there is no mac address programmed, the
following is used by default - 00:10:18:00:00:01.
To view the current IP address configured on the Management interface, enter the show interfaces
management ethernet command.
Related
Commands
Version 7.8.1.0 Introduced on S-Series
ip-address mask
Enter the IP address in dotted decimal format (A.B.C.D) and the mask in /
prefix-length format (/x).
Version 7.8.1.0 Introduced on S-Series
ip address Assign a primary and secondary IP address to the interface.
show default-gateway
Display the IP address configured for the default gateway.
show interface
management ethernet
Display the IP address configured for the Management interface.