Reference Guide

656 | IPv4 Routing
www.dell.com | support.dell.com
• IP source address
• IP destination address
• IP Protocol type
• TCP/UDP source port
• TCP/UDP destination port
The table below lists the load balance command options and how the command combinations effect the
distribution of traffic.
Related
Commands
management route
c e
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address | ipv6-address}/mask {forwarding-router-address |
managementethernet}
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Note: For IPV6, only the first 32 bits (LSB) of IP Source Address and IP Destination
Address are used for hash generation.
Table 24-3. Configurations of the load-balance Command
Configuration Switched IP Traffic
Routed IP Traffic
(IPV4 Only)
Switched Non-IP
Traffic
Default (IP 5-tuple) IP 5-tuple IP 5-tuple MAC based
ip-selection 3-tuple IP 3-tuple IP 3-tuple MAC based
mac MAC based IP 5-tuple MAC based
ip-selection 3-tuple and mac MAC based IP 3-tuple MAC based
ip-selection packet-based
Packet based: IPV4
No distribution: IPV6
Packet based: IPV4 MAC based
ip-selection packet-based and mac MAC based Packet based: IPV4 MAC based
ip address Change the algorithm used to distribute traffic on an E-Series chassis.
{ipv4-address | ipv6-address}/
mask
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X),
followed by the prefix-length for the IP address of the management
interface.
forwarding-router-address
Enter an IPv4 or IPv6 address of a forwarding router.
managementethernet Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Version 8.4.1.0 Added support for IPv6 management routes.
Version 8.1.1.0 Introduced on E-Series ExaScale