Reference Guide

IPv4 Routing | 643
• Internet Control Message Protocol* icmp
* but not the ICMP message type (0-255)
• Any Internet Protocol ip
• Transmission Control Protocol* tcp
* but not on the rst, syn, or urg bit
• User Datagram Protocol udp
In the case of ambiguous access control list rules, the debug ip packet access-control command will be
disabled. A message appears identifying the error (see Figure 24-4).
Example
Figure 24-4. debug ip packet access-group Command Errors
ip address
c e s
Assign a primary and secondary IP address to the interface.
Syntax
ip address ip-address mask [secondary]
To delete an IP address from an interface, use the no ip address [ip-address] command.
Parameters
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
You must be in the INTERFACE mode before you add an IP address to an interface. Assign an IP
address to an interface prior to entering the ROUTER OSPF mode.
FTOS#debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
FTOS#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is turned off
FTOS#
ip-address
Enter an IP address in dotted decimal format.
mask
Enter the mask of the IP address in slash prefix format (for example, /24).
secondary (OPTIONAL) Enter the keyword secondary to designate the IP address as the
secondary address.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series