Reference Guide

IPv4 Routing | 641
Parameters
Command Mode
EXEC Privilege
Command
History
access-group name
Enter the keyword access-group followed by the access list name
(maximum 16 characters) to limit the debug output based on the defined rules
in the ACL.
count value (OPTIONAL) Enter the keyword count followed by the count value.
Range: 1 to 65534
Default: Infinity
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet
followed by the slot/port information.
• For the management interface on the RPM, enter the keyword
managementethernet followed by the slot/port information. The
slot range is 0-1 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.2.1.0 Support 4094 VLANs on E-Series ExaScale (prior limit was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added the access-group option
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.3.1.0 Added the count option