Reference Guide

616 | Interfaces
www.dell.com | support.dell.com
Example
Figure 23-42. wanport Command with shutdown Command Example
Related
Commands
Port Channel Commands
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a
single link according to IEEE 802.3ad. In FTOS, a LAG is referred to as a Port Channel.
Table 23-11. Port Channel Limits
Because each port can be assigned to only one Port Channel, and each Port Channel must have at least
one port, some of those nominally available Port Channels might have no function because they could
have no members if there are not enough ports installed. In the S-Series, those ports could be provided
by stack members.
The commands in this section are specific to Port Channel interfaces:
• channel-member
• group
• interface port-channel
• minimum-links
• port-channel failover-group
• show config
interface TenGigabitEthernet 13/0
no ip address
no shutdown
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#wanport
% Error: Port should be in shutdown mode, config ignored Te 13/0.
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#shutdown
FTOS(conf-if-te-13/0)#
FTOS(conf-if-te-13/0)#wanport
FTOS(conf-if-te-13/0)#
ais-shut Send LAIS on shutdown
alarm-report Enable reporting of a selected alarm
clock source Configure a clock source
down-when-looped Send a message when a loopback condition is detected
flag Set flags to ensure interoperability
framing Set framing type
keepalive Enable keepalive
loopback Troubleshoot a SONET loopback
Platform
Maximum Port Channel
IDs
Maximum Members per Port
Channel
E-Series ExaScale 255 64
E-Series TeraScale 255 16
E-Series EtherScale 32 16
C-Series 128 8
S-Series 128 8