Reference Guide

Interfaces | 611
Related
Commands
show range
c e s
Display all interfaces configured using the interface range command.
Syntax
show range
Command Mode
INTERFACE RANGE (config-if-range)
Command
History
Example
Figure 23-41. show range Command Example
Tx Power High Warning Flag This can be either true or false, depending on the Current Tx power value
displayed above.
Rx Power High Warning Flag This can be either true or false, depending on the Current Tx power value
displayed above.
Temperature Low Warning
Flag
This can be either true or false, depending on the Current Temperature value
displayed above.
Voltage Low Warning Flag This can be either true or false, depending on the Current voltage value
displayed above.
Tx Bias Low Warning Flag This can be either true or false, depending on the present Tx bias current value
displayed above.
Tx Power Low Warning Flag This can be either true or false, depending on the Current Tx power value
displayed above.
Rx Power Low Warning Flag This can be either true or false, depending on the Current Rx power value
displayed above.
Table 23-10. Diagnostic Data in show interfaces transceiver (continued)
Line Description
interface Configure a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Display information on a specific physical interface or virtual interface.
show inventory (C-Series
and E-Series)
Display the chassis type, components (including media), FTOS version
including hardware identification numbers and configured protocols.
show inventory (S-Series) Display the S-Series switch type, components (including media), FTOS version
including hardware identification numbers and configured protocols.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced
FTOS(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
FTOS(conf-if-range-so-2/0-1,fa-0/0)#