Reference Guide

BOOT_USER Mode | 61
Figure 4-1. First Field in the boot change Command
Figure 4-2 shows the completed command:
Figure 4-2. Completed boot change Command Example
In the runtime CLI of C-Series and E-Series, use the boot system command to change the boot
image file and location.
To view the current boot configuration, use the show bootvar command.
Related
Commands
boot messages
c e
Limit the number of messages seen during system boot-up.
Syntax
boot messages {disable | enable}
Parameters
Defaults
enable (that is, all messages are displayed during boot up)
Command Modes
BOOT_USER
boot selection
c e
Specify the boot flash partition in the internal Flash from which to boot the system.
Syntax
boot selection [a | b]
BOOT_USER # boot change primary
'.' = clear field; '-' = clear non-essential field
boot device : ftp
BOOT_USER # boot change primary
'.' = clear field; '-' = go to previous field
boot device : ftp
file name : tt/latestlabel
Server IP address : 10.16.1.209
username : amsterdam
password : ******
BOOT_USER #
boot system Set the location of FTOS image files.
boot zero Remove the primary, secondary, or default boot image configuration.
show boot selection Display the current Boot Flash image selected.
show bootvar Display boot configuration information.
disable Enter the keyword disable to display fewer messages during boot-up.
enable Enter the keyword enable to display all messages during boot-up.