Reference Guide

596 | Interfaces
www.dell.com | support.dell.com
Usage
Information
On the C-Series and S-Series, the interface counter “over 1023-byte pkts” does not increment for
packets in the range 9216 > x < 1023.
The Management port is enabled by default (no shutdown). If necessary, use the ip address command
to assign an IP address to the Management port. If two RPMs are installed in your system, use the show
redundancy command to display which RPM is the Primary RPM.
Related
Commands
show interfaces configured Display any interface with a non-default configuration.
show interfaces linecard Display information on all interfaces on a specific line card.
show interfaces phy
show interfaces rate Display information of either rate limiting or rate policing on the interface.
show interfaces switchport Display Layer 2 information about the interfaces.
show inventory (C-Series and
E-Series)
Display the chassis type, components (including media), FTOS version
including hardware identification numbers and configured protocols.
show inventory (S-Series) Display the S-Series switch type, components (including media), FTOS
version including hardware identification numbers and configured
protocols.
show ip interface Display Layer 3 information about the interfaces.
show linecard Display the line card(s) status.
show range Display all interfaces configured using the interface range command.
Note: Unicast counters in the show interface output will increment when the interface receives multicast
or broadcast packets..