Reference Guide

Interfaces | 591
Usage
Use this show interfaces command for details on a specific interface. Use the show interfaces
linecard command for details on all interfaces on the designated line card.
Note that, in an E-Series EtherScale chassis, the show interfaces command output does not include
details about installed SFP or XFP transceivers.
Example
Figure 23-27. show interfaces Command Example for 10G Port (EtherScale in
E-Series)
Version 6.4.1.0 Changed organization of display output
Version 6.3.1.0 Added Pluggable Media Type field in E-Series TeraScale output
Table 23-5. Lines in show interfaces Command Example (EtherScale)
Line Description
TenGigabitEthernet 2/0... Displays the interface’s type, slot/port, and administrative and line protocol
status.
Hardware is... Displays the interface’s hardware information and its assigned MAC address.
Interface index... Displays the interface index number used by SNMP to identify the interface.
Internet address... States whether an IP address is assigned to the interface. If one is, that address
is displayed.
MTU 1554... Displays link and IP MTU information.
If the chassis is in Jumbo mode, this number can range from 576 to 9252.
LineSpeed Displays the interface’s line speed.
ARP type:... Displays the ARP type and the ARP timeout value for the interface.
Last clearing...
Displays the time when the
show interfaces counters where cleared.
Queuing strategy... States the packet queuing strategy. FIFO means first in first out.
FTOS#show interfaces tengigabitethernet 2/0
TenGigabitEthernet 2/0 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f7:3a
Interface index is 100990998
Internet address is 213.121.22.45/28
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 02:31:45
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
Input 0 IP Packets, 0 Vlans 0 MPLS
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
Output Statistics:
1 packets, 64 bytes, 0 underruns
0 Multicasts, 2 Broadcasts, 0 Unicasts
0 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:00:27