Reference Guide

BOOT_USER Mode | 59

BOOT_USER Mode

Overview

Most of the commands in this chapter are in Configuration mode, except for format, which is in the

BOOT_ADMIN mode. The exception to this is that on the Dell Force10 S50 platform. On the S50, the

commands are accessed from the BOOT_USER mode. Command support on Dell Force10 platforms is

indicated by the characters that appear below each command heading:

•

c = C-Series

• e = E-Series

• s = S-Series

To access the BOOT_USER mode, boot your Dell Force10 platform.When the prompt, “Hit any key

to break into BOOT_USER mode” appears, press a key.

Commands

• boot change

• boot messages

• boot selection

• boot zero

• default-gateway

• delete

• dir

• enable

• format

• ignore enable-password

• ignore startup-config

• interface management ethernet ip address

• interface management ethernet mac-address

• interface management ethernet port

• interface management port config

• reload

• rename

• restore factory-defaults

• save

• show boot selection

• show bootflash