Reference Guide

Interfaces | 589
Defaults 299 seconds
Command Modes
INTERFACE
Command
History
Usage
Information
The configured rate interval is displayed, along with the collected traffic data, in the output of show
interfaces commands.
Related
Commands
show config
c e s
Display the interface configuration.
Syntax
show config
Command Modes
INTERFACE
Command
History
Example
Figure 23-25. show config Command Example for the INTERFACE Mode
show config (from INTERFACE RANGE mode)
c e s
Display the bulk configured interfaces (interface range).
Syntax
show config
Command Modes
CONFIGURATION INTERFACE (conf-if-range)
Command
History
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced
show interfaces Display information on physical and virtual interfaces.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
FTOS(conf-if)#show conf
!
interface GigabitEthernet 1/7
no ip address
switchport
no shutdown
FTOS(conf-if)#
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series