Reference Guide

Interfaces | 579
Related
Commands
interface vlan
c e s
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Command
History
Example
Figure 23-17. interface vlan Command Example
Usage
Information
For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. See Chapter 9, Access Control Lists (ACL).
Related
Commands
interface range Configure a range of command (bulk configuration)
interface range macro (define) Define a macro for an interface range (bulk configuration)
vlan-id
Enter a number as the VLAN Identifier.
Range: 1 to 4094.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
interface Configure a physical interface.
interface loopback Configure a loopback interface.
interface null Configure a null interface.
interface port-channel Configure a port channel group.
show vlan Display the current VLAN configuration on the switch.
shutdown Disable/Enable the VLAN.
tagged Add a Layer 2 interface to a VLAN as a tagged interface.
untagged Add a Layer 2 interface to a VLAN as an untagged interface.