Reference Guide

File Management | 57
Defaults
None.
Command Mode
EXEC Privilege
Command
History
Example
Command example: restore fpga-image
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
upgrade fpga-image
c
Upgrade the primary FPGA image.
Syntax
upgrade fpga-image {rpm {number | all}| linecard {number | all} [system-fpga | link-fpga]
| all} {booted | file-url}
Parameters
Version 7.7.1.0
Renamed keyword
primary-fpga-flash to fpga-image.
Version 7.5.1.0 Introduced on C-Series
FTOS#restore fpga-image linecard 4
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
LC4 48 Port 1G LCM FPGA A: 3.6 restore
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Restore fpga image for linecard 4 [yes/no]: yes
FPGA restore in progress. Please do NOT power off the card.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Linecard 4 FPGA restore successful.
reset Reset a card.
rpm number Enter rpm followed by the RPM slot number to upgrade an RPM FPGA
Range: 0-1
linecard number Enter linecard followed by the line card slot number to upgrade a
linecard FPGA.
Range: 0-7 on the C300, 0-3 on the C150
all Enter the keyword all to upgrade all RPM and linecard FPGAs. Enter the
keyword
all after the keyword rpm to upgrade all FPGAs on all RPMs.
Enter the keyword
all after the keyword linecard to upgrade all FPGAs
on all linecards.