Reference Guide

564 | Interfaces
www.dell.com | support.dell.com
clear dampening
c e s
Clear the dampening counters on all the interfaces or just the specified interface.
Syntax
clear dampening [interface]
Parameters
Defaults
Without a specific interface specified, the command clears all interface dampening counters
Command Modes
EXEC Privilege
Command
History
Example
Related
Commands
cx4-cable-length
s
Configure the length of the cable to be connected to the selected CX4 port.
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
interface
(Optional) Enter one of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
FTOS#clear dampening gigabitethernet 1/2
Clear dampening counters on Gi 1/2 [confirm] y
FTOS#
show interfaces dampening
Display interface dampening information.
dampening Configure dampening on an interface.
long | medium | short
Enter the keyword that matches the cable length to be used at the selected
port:
short = For 1-meter and 3-meter cable lengths
medium = For 5-meter cable length
long = For 10-meter and 15-meter cable lengths