Reference Guide

56 | File Management
www.dell.com | support.dell.com
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
Example
Command example: upgrade sfm autoreset
Related
Commands
0Usage
Information
On E-Series ExaScale, you cannot upgrade SFMs using this command when Cache Boot is configured.
If you attempt an upgrade, you must reload the chassis to recover.
Upgrading the C-Series FPGA
These commands are for upgrading the FPGA for C-Series RPMs and line cards.
• restore fpga-imagee
• upgrade fpga-image
restore fpga-image
c
Copy the backup C-Series FPGA image to the primary FPGA image.
Syntax
restore fpga-image {rpm | linecard} number
Parameters
sfm Enter the keyword sfm to upgrade the FPGA on the SFMs.
rpm Enter the keyword rpm to upgrade all processors on the RPM.
all Enter the keyword all to upgrade the FPGA on all the SFMs.
id Enter the keyword id to upgrade the FPGA on all a specific SFM.
Enter the path to the upgrade source. Entering <CR> updates the FPGA from the flash.
Version 8.3.1.0
Added
rpm option
Version 7.5.1.0 Introduced on E-Series
FTOS#upgrade sfm 1 autoreset
SFM1: upgrade in progress
!!! !!! !!!
SFM1: upgrade complete
SFM1 is active. Resetting it might temporarily impact traffic.
Proceed with reset [confirm yes/no]: yes
FTOS#
show sfm Display the SFM status.
upgrade (E-Series version)
Upgrade the E-Series.
rpm Enter rpm to upgrade an RPM FPGA.
linecard Enter linecard to upgrade a line card FPGA.
number
Enter the line card or RPM slot number.
C-Series Line Card Range: 0-7, RPM Range: 0-1