Reference Guide

544 | High Availability (HA)
www.dell.com | support.dell.com
RPM Redundancy
Configuration
Displays the following information:
• which RPM is the preferred Primary on next boot (redundancy primary
command)
• the data sync method configured (redundancy synchronize command).
• the failover type (you cannot change this; it is software dependent) Hot
Failover means the running configuration and routing table are applied on
secondary RPM. Fast Failover means the running configuration is not
applied on the secondary RPM till failover occurs, and the routing table on
line cards is cleared during failover.
• the status of auto booting the RPM (redundancy disable-auto-reboot
command)
• the parameter for auto failover limit control (redundancy auto-failover-limit
command)
RPM Failover Record Displays the following information:
• RPM failover counter (to reset the counter, use the redundancy reset-counter
command)
• the time and date of the last RPM failover
• the reason for the last RPM failover.
Last Data Sync Record Displays the data sync information and the timestamp for the data sync:
• Start-up Config is the contents of the startup-config file.
• Line Card Config is the line card types configured and interfaces on those
line cards.
• Runtime Event Log is the contents of the Event log.
• Running Config is the current running-config.
This field only appears when you enter the command from the Primary RPM.
Table 21-1. show redundancy Command Example Fields (continued)
Field Description