Reference Guide

High Availability (HA) | 537
Related
Commands
redundancy auto-failover-limit
c e
Specify an auto-failover limit for RPMs. When an non-recoverable fatal error is detected, an automatic
RPM failover occurs. This command does not affect user-initiated (manual) failovers.
Syntax
redundancy auto-failover-limit [count number [period minutes] | period minutes]]
To disable the auto-failover limit control, enter no redundancy auto-failover-limit.
Parameters
Defaults
Count: 3 Period: 60 minutes
Command Modes
CONFIGURATION
Command
History
Usage
Information
If auto failover is disabled, enter the redundancy auto-failover-limit (without any parameters) to
set auto failover to the default parameters (Count 3, Period 60 minutes).Use the show redundancy
command to view the redundancy status.
When you change one or both of the optional parameters, FTOS checks that the interval between auto
failovers is more than five (5) minutes. If the interval is less, FTOS returns a configuration error
message.
redundancy disable-auto-reboot
c e
Prevent the system from auto-rebooting the failed module.
Syntax
redundancy disable-auto-reboot [rpm| card number | all]
To return to the default, enter no redundancy disable-auto-reboot rpm.
Parameters
Defaults
Disabled (that is, the failed module is automatically rebooted).
Command Modes
CONFIGURATION
show processes restartable
count number
Enter the number of times the RPMs can automatically failover within the period
defined in the period parameter.
Range: 2 to 10
Default: 3
period minutes
Enter a duration in which to allow a number of automatic failovers (limited to the
number defined in the count parameter).
Range: 5 to 9000 minutes
Default: 60 minutes
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series
rpm Enter the keyword rpm to disable auto-reboot of the failed RPM.