Reference Guide

528 | GARP VLAN Registration (GVRP)
www.dell.com | support.dell.com
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
disable
c e s
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults
Enabled
Command Modes
CONFIGURATION-GVRP
Command
History
Related
Commands
garp timers
c e s
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave | leave-all} command.
Parameters
Defaults
Default as above
Version 7.6.1.0 Introduced on C, E, and S-Series
Version 7.6.1.0 Introduced on C, E, and S-Series
gvrp enable Enable GVRP on physical interfaces and LAGs.
protocol gvrp Access GVRP protocol
join
Enter the keyword join followed by the number of milliseconds to configure the join
time.
Range: 100-2147483647 milliseconds
Default: 200 milliseconds
Note: Designate the milliseconds in multiples of 100
leave Enter the keyword leave followed by the number of milliseconds to configure the leave
time.
Range: 100-2147483647 milliseconds
Default: 600 milliseconds
Note: Designate the milliseconds in multiples of 100
leave-all Enter the keyword leave-all followed by the number of milliseconds to configure the
leave-all time.
Range: 100-2147483647 milliseconds
Default: 1000 milliseconds
Note: Designate the milliseconds in multiples of 100