Reference Guide

520 | FTOS Service Agent
www.dell.com | support.dell.com
Parameters
Defaults
None
Command Mode
CALL-HOME TEST-LIST
Command
History
Usage
Information
FTOS does not allow you to configure a test that makes no sense, such as cpu-5-min greater-than
number 150. CPU percentage utilization can only go up to 100, so 150 is not possible. FTOS
displays the acceptable range, as shown below
Examples
This example shows a couple other keyword configuration examples.
Related
Commands
test-condition statistic Enter the keyword test-condition, followed by one of the following
statistic request types:
cpu-1-min: Average CPU utilization for 1 minute
cpu-5-min: Average CPU utilization for 5 minutes
interface-bit-rate {input | output} slot#: Instantaneous bit rate
on a given line card
interface-crc interface: Number of CRC errors on a given interface
interface-rate interface: Packet rate on a given interface
interface-throttles interface: Number of throttles on an interface
memory-free: Free system memory
memory-free-percent: Free system memory free in percentage
memory-used: System memory used
memory-used-percent: System memory used in percentage
wred-drops interface: Number of WRED drops on an interface
(E-Series only)
operator Enter one of the following Boolean comparison operators: decrease,
equal-to, greater-than, increase, less-than, not-equal-to,
no-change.
number value Enter the keyword number, followed by an integer to be the comparison
value to the designated statistic, in the range pertinent to the statistic.
cpu | rpm-any
Enter the processor that will be tested: cp, lp, rp1, rp2, or test all RPM CPUs
with the keyword
rpm-any.
Version 8.2.1.0
Removed
message-text keyword. Added operators.
Version 7.8.1.0 Introduced on C-Series and E-Series
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than ?
number The boolean comparison value
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number ?
<0-100> Enter the boolean comparison value
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number 10
FTOS(conf-call-home-testlist-test)# test-condition interface-rate input 1 less-than
number 98
FTOS(conf-call-home-testlist-test)# test-condition memory-used not-equal-to number
1000
dampen Set a delay before sampling for a test condition again after it has been matched.
test-limit Set the number of times that the test list that should be executed.