Reference Guide

52 | File Management

www.dell.com | support.dell.com

S-Series Example

Command output example on an S50V: show version

upgrade (E-Series version)

Upgrade the bootflash, boot selector, or system image on a processor.

Syntax

upgrade {bootflash-image | bootselector-image | system-image} {all | linecard

linecard-slot | rpm} {booted | file-url}

Parameters

128K bytes... Amount and type of memory on system.

1 Route Processor... Hardware configuration of the system, including the number and type of

physical interfaces available.

show version Command Fields

Lines beginning with Description

FTOS#show version

Force10 Networks Real Time Operating System Software

Force10 Operating System Version: 1.0

Force10 Application Software Version: E7-8-1-13

Build Time: Mon Nov 24 18:59:27 2008

Build Path: /sites/sjc/work/sw/build/build2/Release/E7-8-1/SW/SRC

Force10 uptime is 1 minute(s)

System Type: S50V

Control Processor: MPC8451E with 252739584 bytes of memory.

32M bytes of boot flash memory.

1 48-port E/FE/GE with POE (SB)

48 GigabitEthernet/IEEE 802.3 interface(s)

4 Ten GigabitEthernet/IEEE 802.3 interface(s)

FTOS#

bootflash-image Enter the keyword bootflash-image to upgrade the bootflash image.

bootselector-image Enter the keyword bootselector-image to upgrade the boot selector

image.

Use with TAC supervision only.

system-image Enter the keyword system-image to upgrade the cache boot image.

all Enter the keyword all to upgrade the bootflash/boot selector image on all

processors in the E-Series. This keyword does not upgrade the bootflash on

the standby RPM.

linecard linecard-slot Enter the keyword linecard followed by the slot number to change the

bootflash image on a specific line card.

E-Series Range: 0 to 13 on the E1200; 0 to 6 for the E600; 0 to 5 on the

E300

rpm Enter the keyword rpm to upgrade the bootflash/boot selector image on all

processors on the RPM.