Reference Guide

514 | FTOS Service Agent
www.dell.com | support.dell.com
Command Mode
conf-callhome-policy
Command
History
Related
Commands
server
c e
Use this command to create a server name to be associated with a particular recipient.
Syntax
server name
To remove a server and the associated recipient, use the no server name command.
Parameters
Defaults
FTOS
Command Mode
CONFIGURATION Server (conf-callhome)
Command
History
Example
Figure 19-2. server (FTSA) Command Example
Usage
The Dell Force10 server name is configured for FTSA messages to be sent by default to Dell Force10
Support at [e-mail]. If you want to change that address, enter the command server
FTOS. You will be placed at that server-specific prompt (conf-callhome-FTOS), where you would then
use the recipient command to enter a new address.
In addition to modifying the Dell Force10 server recipient, you can identify up to four more server
names and associated recipients.
Version 7.8.1.0 Introduced on C-Series and E-Series
policy Create a policy with a name and enter config-callhome-policy-name mode.
policy-test-list Name a policy test list and enter the config-callhome-actionlist-name mode.
test-condition
(comparing samples)
Collect multiple samples of a statistic and compare them using the specified
comparator and hurdle value.
test-condition
(comparison to a
value)
Collect a sample of a designated statistic and then compare it to the designated
number.
test-condition
message-text
(deprecated)
Search for a stated value in the output of the designated
show command or message
type.
test-limit Set the number of times that the test list should be executed.
name
Enter the name of the server in alphanumeric format, up to 25 characters long.
Version 7.6.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced for E-Series
FTOS(conf-callhome)#
FTOS(conf-callhome)#server freedom_bird
FTOS(conf-callhome-freedom_bird)#?