Reference Guide

504 | FTOS Service Agent
www.dell.com | support.dell.com
domain-name
c e
Specify the domain name for the Administrator’s email address.
Syntax
domain-name domain_name
To remove the domain name, use the no domain-name command.
Parameters
Defaults
The domain name specified in the admin-email command
Command Modes
CONFIGURATION (conf-callhome)
Command
History
Usage
Information
If you use this command to specify a domain name, that domain name is used instead of any domain
name that you might have specified using the admin-email command.
Related
Commands
enable
c e
Enable the sending of FTSA email messages to the selected recipient.
Syntax
enable
To disable (end) the sending of FTSA email messages to the selected recipient, use the no enable
command.
Defaults
no enable
Command Modes
conf-callhome
Command
History
Usage
Information
If you leave the selected recipient in the default condition of disabled (no FTSA email messages to the
selected recipient), you can either come back to this command later, or you can use the enable-all
command. If you use the enable-all command, you can then disable email messages to the recipient
with the no enable command at the server-specific prompt.
FTSA sends an email notification to the selected recipient whenever the enable status changes.
domain name
Enter the keyword domain-name followed by the complete domain name of the
Administrator’s email address, for example, domain_name.com.
Version 7.6.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced for E-Series
admin-email Enter the Administrator’s email address.
call-home Start FTSA and Enter the FTSA mode.
Version 7.6.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced for E-Series
Note: Execute the enable command only after the SMTP and admin-email commands are
executed.