Reference Guide

FTOS Service Agent | 503
default-test
c e
Invoke one of three preset system-monitoring test groups.
Syntax
default-test {hardware | software | exception}
Parameters
Defaults
None
Command Mode
CALL-HOME TEST-LIST
Command
History
Usage
Information
Executing the policy-test-list command puts you in the config-callhome-testlist mode, where you
use this command to invoke one of three possible test groups. FTOS monitors the system for any event
in the selected test group. If such an event occurs, FTOS invokes the action you define using the
default-action command.
Related
Commands
description
c e
Enter a description for the Call Home mode.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
None
Command Modes
CONFIGURATION-CALLHOME
Command
History
Related
Commands
hardware Enter the keyword hardware to monitor hardware conditions. See the FTOS
Configuration Guide for the list of conditions monitored by this keyword.
software Enter the keyword software to monitor software conditions. See the FTOS Configuration
Guide for the list of conditions monitored by this keyword.
exception Enter the keyword exception to monitor the exceptions events. See the FTOS
Configuration Guide for the list of conditions monitored by this keyword.
Version 7.7.1.0 Introduced on C-Series and E-Series
default-action Select the information collection action that matches the selected test group.
policy-test-list Name a new or existing test list and enter the config-callhome-testlist-name mode.
description
Enter a description to identify the Call Home mode(80 characters maximum).
pre-7.7.1.0 Introduced
call-home Enter the Call Home mode on the switch.