Reference Guide

FTOS Resilient Ring Protocol (FRRP) | 489
Command
History
Usage
Information
This command causes the Ring Manager to take ownership of these two ports after the configuration is
validated by the IFM. Ownership is relinquished for a port only when the interface does not play a part
in any control VLAN, that is, the interface does not belong to any ring.
Related
Commands
member-vlan
c e
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-frrp)
Command
History
mode
c e
Set the Master or Transit mode of the ring.
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
Parameters
Defaults
Mode None
Command Modes
CONFIGURATION (conf-frrp)
Command
History
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
show frrp Display the Resilient Ring Protocol configuration information
vlan-range
Enter the member VLANs using comma separated VLAN IDs, a range of VLAN IDs, a
single VLAN ID, or a combination. For example:
Comma separated: 3, 4, 6
Range: 5-10
Combination: 3, 4, 5-10, 8
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
master Enter the keyword master to set the Ring node to Master mode.
transit Enter the keyword transit to set the Ring node to Transit mode.
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced