Reference Guide

442 | Content Addressable Memory (CAM)
www.dell.com | support.dell.com
cam ipv4flow (EXEC Privilege)
e
t
Configure the amount of CAM space in IPv4flow sub-regions.
This command is deprecated as of FTOS 8.3.1.0
Syntax
cam ipv4flow {chassis all | linecard number} {default | acl value multicast-fib value pbr
value qos value system-flow value trace-list value}
Command Modes
EXEC Privilege
Command
History
cam-ipv4flow (CONFIGURATION)
e
t
Configure the amount of CAM space in IPv4flow sub-regions.
Syntax
cam-ipv4flow {default | multicast-fib value pbr value qos value system-flow value
trace-list value}
Parameters
Defaults
See Parameters
Command Modes
CONFIGURATION
Version 8.3.1.0 COMMAND DEPRECATED
Version 6.3.1.0 Introduced on E-Series
default Enter the keyword default to reset the IPV4Flow CAM region to its default
setting.
multicast-fib value Enter the keyword multicast-fib followed by the number of entries for the
multicast FIB sub-region in 1K increments.
Range: 1 to 32 KB
Default: 9 KB
pbr value Enter the keyword pbr followed by the number of entries for the PBR
sub-region in 1K increments.
Range: 1 to 32 KB
Default: 1 KB
qos value Enter the keyword qos followed by the number of entries for the QoS
sub-region in 1K increments.
Range: 1 to 32 KB
Default: 8 KB
system-flow value Enter the keyword system-flow followed by the number of entries for the
system-flow sub-region in 1K increments.
Range: 4 to 32 KB
Default: 5 KB
trace-list value Enter the keyword trace-list followed by the number of entries for the
trace-list sub-region in 1K increments.
Range: 1 to 32 KB
Default: 1 KB